Ebyte E104-BT30, User Manual

Page: 9 / 12

Chengdu Ebyte Electronic Technology Co.,Ltd E104-BT30 User Manual
Copyright ©2012–2019
，
Chengdu Ebyte Electronic Technology Co.,Ltd
5-8
the module and routed in the Bottom Layer
；

Assuming the module is soldered or placed over the Top Layer, it is wrong to randomly route over the Bottom Layer
or other layers, which will affect the module's spurs and receiving sensitivity to varying degrees
；

It is recommended to use a USB or battery to power the module. The ripple factor of the power supply should be as
small as possible, and the module should be reliably grounded;

Please pay attention to the correction of the positive and negative of the power supply, reverse connection may
cause permanent damage to the module;

Please check the power supply to ensure that it is between the recommended power supply voltage, if the maximum
value is exceeded, the module will be permanently damaged;

When designing current supply circuit, 30% margin is recommended to be remained so as to ensure long-term
stable operation of the whole module;

The module should be as far away as possible from the power supply, transformers, high-frequency wiring and other
parts with large electromagnetic interference;

It is assumed that there are devices with large electromagnetic interference around the module that will greatly
affect the performance. It is recommended to keep them away from the module according to the strength of the
interference. If necessary, appropriate isolation and shielding can be done;

Assume that there are traces with large electromagnetic interference (high-frequency digital, high-frequency analog,
power traces) around the module that will greatly affect the performance of the module. It is recommended to stay
away from the module according to the strength of the interference. If necessary, appropriate isolation and shielding
can be done;

The module must not be installed inside metal shield, which will greatly reduce the transmission distance.
4.2 Recommended application circuit
Refer to "Recommended Circuit.pdf" for recommended circuit.
5. FAQ
5.1 Communication range is too short

The communication distance will be affected when obstacle exists.

Data lose rate will be affected by temperature, humidity and co-channel interference.

The ground will absorb and reflect wireless radio wave, so the performance will be poor when testing near ground.

Seawater has great ability in absorbing wireless radio wave, so performance will be poor when testing near the sea.

The signal will be affected when the antenna is near metal object or put in a metal case.

When the power supply at room temperature is lower than the recommended low voltage, the lower the voltage is,
the lower the transmit power is.
5.2 Module is easy to damage

Please check the power supply and ensure it is within the recommended range. Voltage higher than the peak will