Chengdu Ebyte Electronic Technology Co., Ltd.
Copyright©2012–2021
ChengduEbyteElectronicTechnologyCo,;Ltd
17
01
：
37dbm
10
：
37dbm
11
：
37dbm
-------------------------------------
--------------------------------------
Power and current are nonlinear, and
power efficiency is highest at
maximum power.
The current does not decrease in
proportion to the decrease in power.
05H
Read/
Write
REG2
Channel
（
CH
）
0-83
stands
for
84
channel
respectively
Actual frequency= 410.125 + CH
*1M
06H
Read/
Write
REG3
7
enable RSSI byte
1
：
on
0
：
off
（
Default
）
--------------------------------------------
6
，
fixed transmission
1
：
fixed transmission
0
：
transparent transmission
（
Default
）
--------------------------------------------
5
enable repeater
1
：
on
0
：
off
-------------------------------------------
4
enable LBT
（
listen before
transmit
）
1
：
on
0
：
off
（
Default
）
-------------------------------------------
3
WOR TX and RX control
1
：
WOR transmitter
TX and RX are enabled,
certain preamble code is added when
transmitting date. Data receiving is
on.
0
：
WOR
receiver
（
Default
）
Transmission
is
unavailable. Module works in WOR
monitoring, (see details about WOR
time below) to save power.
---------------------------------------------
--
2
，
1
，
0
，
WOR time
000
：
500ms
001
：
1000ms
010
：
1500ms
011
：
2000ms
（
Default
）
When enabled, the module receives
wireless data and it will follow an
RSSI strength byte after output via
the serial port TXD
.----------------------------------
The module recognizes the first
three bytes of the serial data as:
address high + address low +
channel and takes it as the wireless
transmitting target.
---------------------------------------
After the reply function is enabled, if
the target address is not the module
itself, the module will forward it
once.
In order to prevent data return-back,
it is recommended to use it in
conjunction with the fixed point
mode. That is: the target address is
different from the source address.
-----------------------------------
When enabled, wireless data will be
monitored before it is transmitted,
which can avoid interference to a
certain extent, but may cause data
delay.
-------------------------------------
Only valid in Mode 1.
After the WOR receiver receives the
wireless data and outputs it through
the serial port, it will wait for
1000ms before entering the WOR
again. Users can input the serial port
data and return it via the wireless
during this period. Each serial byte
will be refreshed for 1000ms. Users
must transmit the first byte within
1000ms.
--------------------------------------
Only valid in Mode 1.
Time T=
（
1+WOR
）
*500ms
，
Max
4000ms
，
Min 500ms
The longer the WOR monitoring
Summary of Contents for 400SL37
Page 1: ...E90 DTU 400SL37 ...
