EPX400-xC – Manual
Page 61 / 73
8.11.
DEVICE MONITOR
“Device Monitor” provides real-time information on device state. To use this function
device must be connected to PC computer with GD-PROG cable (the switch in position
DEBUG). Correct RS232 port must be chosen in “Port” field. “Device monitor”
provides following information:
o
AC power indication
o
Battery power indication
o
PSTN line indication
o
GSM network signal level indication
o
Bit-Error-Rate level measuring
o
Inputs and outputs state monitoring
o
Type or serial number of device
o
Firmware and hardware revision
o
Device time
These parameters are also shown in LOG window in text style. All data can be saved
to file.
Note: Relay output “NC-NO-C” in the Device Monitor window are presented as OUT3
8.11.1.
Monitoring data is encrypted
If the device is set to device monitor code (see chapter 8.1.1.4 Device Monitoring
Code), select this option. If you select and press the "Play" button, a window will
appear asking you to enter the device monitor code. If the code is entered correctly,
you can view the status of the device.
Summary of Contents for EPX400-5C
Page 20: ...EPX400 xC Manual Page 20 73...
Page 63: ...EPX400 xC Manual Page 63 73...
