CPX200NB ALARM CONTROL UNIT – INSTALLER MANUAL
23 / 116
2.
Partition does not have any perimeter exit zones.
Correct code will be confirmed by the keypad by 3 beeps.
Leave the facility before the time for leaving expires. That state is indicated by
intermittent sound and quick flashing the ARMED LED on the keypad until the system
gets fully armed. If the chirps are activated the arming will be confirmed by one chirp of
siren.
5.3.
ARMING THE SYSTEM WITH FAULT
If during the arming any faults are present in the system, the keypad will indicate it with
flashing ARMED and SYSTEM LEDs and long constant sound audio signal. LEDs 1 to 8 will
indicate which system errors are present. That state will maintain for 10 seconds. If there is
no possibility to quickly remove faults, press
to arm the system. Pressing
will
cancel the arming process.
Note: Remove the causes of faults as soon as possible.
Error codes:
1 – Damage or disruption of detector
2 – Damage of signalling device or signalling device active
3 – Damage of internal connection or sabotage
4 – AC power supply damage
5 – Battery damage
6 – ATS damage
8 – Other damages
5.4.
DISARMING THE SYSTEM
1.
Enter the facility through the entrance door. Intermittent sound and slow flashing of
ARMED LED on the keypad will remind of the need to disarm the system before the delay
time for entry expires.
2.
Enter the code and press
. 3-tone beep of the keypad will confirm the correct code
input. The partition the user has access to will be disarmed. If the chirps are activated
the disarming will be confirmed by two chirps of siren. If the user has access to all
partitions, all of them will be disarmed. If there is no armed partitions in the system,
ARMED LED will be deactivated.
3.
The system can be disarmed in different way - by changing the partition state. See item
5.5.
4.
When system is disarmed, alarm will be muted (deactivated).
Note: Incorrect code input will be signalled with a long constant
sound. Enter the correct code immediately and press
.
