51
Detection of incorrect position of the device results in transmission of a signal
informing the monitoring system operator of this fact.
TEST
For proper control of data transmission channel device is sending to the
monitoring receiver periodic signal. That signal ensure that device is working, is
connected to GSM network and is connected to the communication server.
BATTERY DISCHARGED
When battery is discharged (read chapter 6. for information about signaling
discharged battery), Active Track will sent proper message to the server.
BATTERY CHARGING STARTS
When device is charged in appropriate charger, Active Track will sent
proper message to the server.
BATTERY FULLY CHARGED
When battery is fully charged, proper message will be sent to the receiver.
BATTERY FULLY DISCHARGED
When the battery is discharged to the extent not allowing for its further
operation, the device saves this information into memory and turns off.
Appropriate information is sent to the monitoring system operator after the
correct power supply is restored.
RESET
The device was manually reset using an appropriate combination of buttons. A
report is transmitted after re-establishment of communication link.
POWER OFF
The device was manually turned off using an appropriate combination of buttons.
A report is transmitted after you turn the device on (using any of the buttons)
and re-establishment of communication link.
CONFIGURATION CHANGE
Each change of configuration (e.g. SMS message with new settings) will end with
sending proper message to the receiver.
CLIP
Any incoming call from a number not appearing on the list of authorized
numbers results in connection refusal and transmission of the corresponding
signal to the monitoring system operator.
WATCHDOG
Following a defined time of GSM/GPRS connectivity disruption the device
performs a specified action (e.g. modem reset) and saves appropriate
information into memory. When the connectivity is re-established, the
information is sent to the monitoring station in order to allow for subsequent
analysis of the system operation
.
Note:
Please remember that the device connects to the server in a periodic
manner (see chapter 7.2.3.1.2). The device will send all the memory
content as soon as it is connected to the server.
