18-5-2011 8 033000=15301
A
Note:
If your equipment doesn't have
CHAN+
you can use
PLAY
(DVR or
DVD) (15) or
POWER
(1) key. The search starts after the last registered code. If
that was 030, the search starts at 031 until the last possible code and then
goes from 000 to 029. Note: if certain functions of your equipment can’t be
controlled you will have to find a different code for your brand.
4.5 Learning codes
Your TAKE 6 Remote contains the codes for most TVs, videos etc. in its code
library. If a certain device is not in this library, you can learn the codes for
your existing remote control. The library may also contain a code that works
for your device, but which misses a few function buttons. You can then
select to only learn those buttons (maximum of 150 buttons).
Master clear
You can use the MASTER CLEAR method to clear the learning memory. It is
advised to execute a MASTER CLEAR before you start learning any
commands.
1. Keep the
SETUP
(8) pressed until the LED stays lit. Release the
SETUP
(8)
button.
2. Press the
LEARN
(20) button twice. The LED will flash every time you press
the button.
3. Press
SETUP
(8). The LED will extinguish after a few seconds.
Notes:
• Execute a Master Clear before you start learning (see the method above).
• Make sure both remote controls have full batteries before you start
learning codes.
• Make sure you do not move the remote controls when pressing the
buttons.
• You cannot learn any commands for the following buttons: Learn, Setup,
FAV, Source buttons TV, VCR, CBL, etc, Home Control.
• Experiment by learning two or three buttons first (to test compatibility),
before you learn all the buttons of your original remote control.
• When the memory is full, the LED will flash for 3 seconds. You cannot learn
any codes when the memory is full. You can, however, erase a mode with
codes you stored. You can only erase a full mode.
• By keeping the buttons for the existing remote control pressed for a shorter
period, there will be more memory space left for learning codes on the TAKE
6 remote control. This also diminishes the chance that the remote control
learns the wrong codes.
• Experiment with the distance between the remote controls if you have
problems learning the codes.
• Some remote controls do not have the infrared LED in the centre. Try
experimenting by slightly moving the remote controls (sideways or
up/down). Tube lighting and bright sunlight can affect the procedure.
• You can only learn the codes for one original remote control per mode,
e.g. the codes for your DVD remote control under the DVD button. With
some combi devices (e.g. a TV with built-in DVD player) you first have to
learn the TV functions in TV mode and then the DVD functions in DVD mode.
Learning the commands
1. Point your existing remote control at the TAKE 6 Remote (front
to front
).
Keep a distance of 2,5 cm between the remote controls.
2. Press the SETUP (8) button until the LED stays lit. Release the SETUP (8)
button.
3. Press the Mode button (TV, AUDIO, SAT, etc.) for the device you want to
learn. The LED will flash once.
4. Press the LEARN (20) button. The LED will flash once.
5. Press the button on the TAKE 6 remote you want to store the new
command under. The LED will blink once.
6. Depending on the type of remote control you have, you can use one of
two methods:
a. Press the button on the existing remote control you want to learn.
Keep this button pressed until the LED on the TAKE 6 Remote
extinguishes. If the LED does not extinguish, but starts flashing, you
need to use method B. (If youhave just tried method A and want to
try method B, first repeat step 5).
