ZIBU Z26HD
EN
47
www.eberg.eu
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The appliance
does not come on
• There is no current
• It is not plugged into the mains
• The internal safety device has
tripped
• Wait
• Plug into the mains
• Wait 30 minutes, if the problem
persists, contact your service center
The appliance
works for a short time
only
• Here are bends in the air
exhaust hose
• Something is preventing the air
from being discharged
• Position the air exhaust hose
• correctly, keeping it as short
• and free of curves as possible to
avoid bottlenecks
• Check and remove any obstacles
obstructing air discharge
The appliance
works, but does not
cool the room
• Windows, doors and/or curtains
open
• There are heat sources in the
room (oven, hairdryer, etc)
• The air exhaust hose is detached
from the appliance
• The technical specification of
the appliance is not adequate
for the room in which it is
located
• Close doors, windows and curtains,
bearing in mind the „tips for correct
use” given above
• Eliminate the heat sources
• Fit the air exhaust hose in the
housing at the back of the
appliance
Fit the air exhaust hose in
the housing at the back of
the appliance
• Air filter clogged
• Clean the filter as described above
The appliance
does not operate for
about three minutes
after restarting it
• The internal compressor safety
device prevents the appliance
from being restarted until three
minutes have elapsed since it
was last turned off
• Wait. This delay is part of normal
operation
The following message
appears on the display:
Lt: / PF / Ft:
• The appliance has a self diagnosis
system to identify a number of
malfunctions
• See the SELF-DIAGNOSIS Chapter
