VIDO 100
EN
12
www.eberg.eu
ASSEMBLY
Tighten the
screws
Square hole
STEP 1
STEP 2
STEP 3
Please install in sequence. (Please keep the
packaging for use in future.)
STEP 1
Place the power cord into the center hole of
the front and rear base, and then close the front
and rear base, as shown in step 2.
STEP 2
Pass the power cord through the center hole
of the rear base.
STEP 3
After the base combined, make the square
hole of basis aim the square convex platform of the
body, then use the screwdriver to tight the screws,
and then put the product in the right position.
Position the Tower Fan on a flat and even surface where it will not cause obstruction or injury.
Connect the appliance to a suitable mains outlet. The Tower Fan will bleep and display the
current room temperature to indicate the appliance is operational.
First, press the ON/OFF button to start. Once activated, you can then select your desired
function using the Control Panel or Remote Control as described on the previous page.
Front base
Body of fan
Power cord
Rear base
Body of fan
Power cord enter
from heare
