FANTO 120
EN
15
www.eberg.eu
STEP 3
Then attach the assembled base to the fan body using the four screws included in the kit.
Pass the power cord through the hole in the edge of the base.
Place the fan on a flat and level surface where it will not be an obstacle.
Connect the device to an appropriate outlet. The fan will be in standby mode.
First, press the main switch (ON / OFF) to start the device. After starting, you can select and set
any function using the control panel or remote control, as described in the instructions in this
manual.
The following descriptions of the functions of each button refer to the control panel on the
device and the remote control.
ON / OFF button
- press once to turn on the fan. After switching on, it will work with the average
fan speed. Press again to return to the standby state.
SPEED button
- use to select the fan speed from among the available options: low, medium,
high speed.
SWING button
- use to enable / disable the oscillation function. After running this function, the
fan will rotate around its own axis from right to left. In this way, the ventilation range generated
by the fan will increase.
ION button
- use to turn on / off the air ionization function.
TIMER button
- use to start the timer and set the length of time after which the fan should turn
off. The programmer allows you to program the fan off time in the range of 1 to 12 hours.
TURN OFF SCREEN button
- is used to blank the display screen, eg when using the device at
night, so that the display light does not disturb during sleep.
FUNCTIONS & OPERATION
