EBH
EN
11
www.eberg.eu
The heating element glowing
The input voltage is too high
or too low
Use power supply according to
the rating on the label
The input voltage is too high
or too low
Keep the heater far way from
articles like curtain, plastic bag,
paper and other things which
can cover the inlet or can be
easily cover on the air inlet
The appliance didn’t heat up,
only ventilator worked
The switch was not put at
heating setting
Turn the switch to heat setting
The thermostat operated
Turn the thermostat and listen if
there is open/close voice. If there
is no click and the thermostat
is not damaged, the heater will
automatic switch on when the
appliance cooled down
The self retting cut-out
operated
Turn the heater off and inspect
the blockage of inlet or outlet.
Disconnect the plug and wait
at least 10 minutes for the
protection system to reset
before attempting to restart the
heater.
Abnormal noise
The appliance is not stands
upright
Put the heater on a level surface
