18
EBA 721-05
21-02
05-02
Mounting the blade
- Turn or replace the cutting stick
©
see „Turning or
replacing the cutting stick“.
- Push the replacement blade with the blade chan-
ging tool (31) mounted into the blade carrier (30)
to the top and screw into place with the grips.
- Lightly tighten 4 of the 6 blade screws (29) (with
washers).
- Remove the blade changing tool.
- Lightly tighten the remaining blade screws (with
washers) (2).
- Remove all tools.
- Position a sheet of paper along the entire cutting
length.
- Lower the blade by pressing both cut buttons.
Keep one button pressed and turn off the main
switch.
- Lower the blade depth adjustment (27) until the
blade touches the paper.
- The 3 eccentrics (28) should then be used to
lower the blade until the paper is cut along the
entire length of the blade
©
(The blade must
remain parallel to the cutting stick).
- Turn main switch to position "I".
- When the blade is in the upper position tighten the
6 blade screws firmly.
- Cut a stack of paper to test.
The blade cannot be ground if the blade height is
82 mm/ 3,23 inches a new blade must be used.
Warning!
Blades may only be sharpened by a specialist.