3
Cancel the memory of the receiver: keep pressed the
P1-PROG
for 12 seconds, when the receiver sounds, release the button.
TRANSCEIVER v2
Technical manual
-12-
1
Put all
DIP-SWITCHES
in OFF position (Tx and Rx)
2
Supply power to the receiver 12/24 Vac/dc,
if 12V make a link to JUMPER 12V.
LED-0 and LED-1 flashes fastly and the receiver make a “beep” sound.
TX
RX
7
Press and keep pressed both
P1
and
P2
of the transmitter
8
After 5 seconds the l.e.d. are lit on to indicate the cancellation of the memory.
Release the buttons.
The memory will be cleared of all previously memorized
installations.
First Installation
Receiver
Cancel of the memory of the receiver
This operation should be done at the first installation
Transmitter
4
Connect to the terminal board the N.C. contact or the 8.2 K resistive edge contact
5
Select the input with DIP-SWITCH 2 for Input 1 and DIP-SWITCH 3 for Input 2:
OFF: Select an input for a N.C. contact
ON: For a 8.2 K resistive edge contact
6
Give power supply on the TX with two 1,5V batteries LR06 AA:
LED-1 of the transmitter fl ashes fast and then slowly.
Reseting the TX
This operation should be done at the first installation.
12 V
24 V
P1 PROG
>
P1 PROG
>
BUZZER
ON
DIP 2-3 TX
ON 8K2 - OFF NC
Safety edge 1
COM coste
Safety edge 2
7
8
9
led
TX1
P1 - TX
P2 - TX
+
led
TX1
1 2 3 4
1 2 3 4
