User Manual Mystère June 2001
eb
PRO
PRO
motion
, Cité Robinson10 2074 Marin, Switzerland
www.ebpromotion.ch
10
Tel +41(0)32 763 05 63 Fax +41 (0)32 763 05 64 e-mail: erich@ebpromotion
How to install the HF Transmitter Interface
The adapter is designed to receive different types of transmitters and to enable the use of
systems which are already in the possesion of the customer. Almost all of these transmitters
offer a plug-in connector and have the audio input connector located on the same side as the
antenna. Therefore, we decided to keep our design strictly to the minimum allowing
connection of most existing RF equipment. However, some mecanical modification may be
needed to adapt each different make and model of transmitters.
Connecting Sennheiser SK series
Each adaptor kit, whether delivered with the mixer or
seperatly, includes a small printed circuit board with a 15 pin
D-sub connector. This PCB accepts resistors to attenuate the
mixer’s 0dBu output to the sensitivity requirements of the
particular radio transmitters input.
Use standard cables and attenuator resistors from your
supplier of the transmitter and solder them on to the circuit.
Attach the circuit to the adaptor with two M 2.5 screws.
Then, attach the entire adapter assembly against the cover of
the Mystère. Connect your transmitter via the cable and slide
it into the opening of the adapter.
Some of our customers simply slide the transmitter in using
the belt clip to hold it against the adapter. Others prefer to use
rubber foam with the necessary thickness to have the
transmitter held tight within the adaptor.
If you use rubber foam, make sure it is water rejecting for
protection of both the mixer and transmitter.
•
The circuitry is protected by a fuse to avoid damage to your equipment. However, as our
guarantee may be refused in case of damage caused by non authorised people, we recom-
mend to have this installation done by your nearest authorized Mystère – dealer.
