EN
3
Setting the Gear Mesh
Charging the Battery
Lithium Polymer (LiPo) Battery Warning
The gear mesh is the clearance between the pinion and spur
gears in your vehicle. If the motor or gearing components are
replaced,check that the gears are not meshing too tightly as
this may cause premature wear.
1.Connect the charger to a USB port then connect the battery to the charger.
2.When charging,the Green LED is flash, when charged, the Green LED is stable.
3.Do not let the battery charge unattended!
4. If the battery or charger is hot,disconnect the battery and charger immediately as this may be
caused by an internal short- circuit.
Never charge a lithium polymer battery with a charger designed for Nicd, NIMH, or any other type of battery
chemistry.Use ONLY charger designed for LiPo battery.
Do not leave LiPo battery unattended during charging.
Do not overcharge the battery.
Always charge LiPo batteries on non-flammable
，
heat-resistant surfaces.
Always use a LiPo-safe bag or container while charging. Do not allow LiPo cells to overheat at any time.Cells which
reach greater than 140 Fahrenheit (60
℃
) will usually become damaged and will catch fire.
Do not charge the LiPo pack while it is still in the model.Never charge or store battery packs in a vehicle.
Do not discharge LiPo
；
doing so will damage the battery.
Do not expose LiPo cell to water or moisture at anytime.
Do not store battery near open flame or heater.
Do not assemble LiPo cells or pre-assembled packs together with other LiPo cells or packs.
Always store LiPo battery in a secure location away from children.
Always remove the LiPo battery if model is involved in any kind of crash.
Carefully inspect the battery and connectors for even the smallest damage..
CAUTION
:Cells may become hot after usage.Allow the pack to cool to room temperature prior to recharging.
Do not allow the electrolyte to get into eyes or on skin.Wash affected areas immediately if they if they come
into contact with electrolyte.Do not alter or modifv connectors or wires of a LiPo battery pack.
Always inspect the condition of the battery before charging and operating.
Do not short circuit the LiPo battery.
Do not have contact with a leaky/damaged battery directly.
Do not charge battery out of recommended temperature range(0°C-45°C).
