4
– SMS4
SMS4 –
5
4. INSTALLATION
The special hexagonal shape of the cabinet makes it possible to
position the speaker in various way, as shown in the figure. The
EAW Commercial plate on the front protective grille can be rotated
to adapt it to the position of the speaker. The speaker body has
four M6 threaded inserts, one each on the top and bottom and
two on the back, used for attaching accessories for installing the
speaker in different ways.
The SMS4 (SMS4W) loudspeakers are supplied with a black
(white) ball joint support for wall mounting.
WARNING:
Consult a professional rigger or structural
engineer prior to suspending loudspeakers from a
structure not intended for that use. Always know
the working load limit of the structure supporting
the loudspeaker array. Always make sure that the
rigging hardware minimum rating is at least five
times the actual load.
5. REAR PANEL FEATURES AND CONTROLS
1. This rotary control selects the power tap for the internal constant voltage transformer. Choices
are 1W, 5W, 10W, 20W, 30W, and BYPASS (used for 4 ohm operation).
2. This rotary control selects the constant
voltage distributed system in which the
speaker is used. Choices are BYPASS
(used for 4 ohm operation),
0 (Off), 25V, 50V, 70V and 100V.
Note: Use a slot-head screwdriver to
adjust the rotary controls.
6. CONNECTIONS
The spring-loaded speaker terminals are designed to accept
bare wire, up to a maximum of 18 gauge. Strip 1/4’’ (6 mm) of
insulation off the end of the speaker wire, press in the tab, and
insert the bare wire into the hole. When you release the tab, the
wire is locked in place. Make sure there are no stray strands of
wire outside the terminal connection.
WARNING:
To prevent the risk of electrical shock,
always fit the protective cover of the terminals after
completing connections.
+
-
SMS4
���������������������������������������
Ω
���
������
�
Ω
��
����
��
���
���
�
���
���
���
����
