Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
20
AC6
Quickstart Guide
5. Installation of AC6 to wall bracket
a. Before mounting the AC6, wires should be
run to the intended locations. Consider the
orientation of mounting, power will either
come from the top down, or the bottom up.
b. Network, analog audio, and dry contacts
can be looped from either end. Refer to user
manual for more information.
c. Using pre-wired cabling, wire the AC6 unit in
both upper and lower locations.
d. If WP covers are being used, install the
covers at this stage.
e. Using two people, line up the flush wall
mount to the AC6 bracket, then slide into
place.
f. The button head screws (M6x35) on the
cabinet bracket are loose, it will be tightened
once the cabinet is mounted to the wall
bracket. Have a 4mm allen driver available to
tighten immediately.
The cabinet should not
be left unattended if this hardware has not
been tightened
.
g. Using 4mm allen, tighten the button head
screws so the cabinet cannot be removed from
the mount.
h. . If additional cabinets are being mounted,
repeat steps 5 and 6 until all units within an
array are mounted.
Installed flush mount bracket
Summary of Contents for AC6
Page 1: ...Quickstart Guide AC6...
