Eaton XV200, Operating Instruction

Page: 50 / 60

7 Maintenance and service
7.4 Troubleshooting
50
MICRO PANEL XV200
10/2011 MN04802007Z-EN www.eaton.com
7.4 Troubleshooting
Fault and possible cause Corrective action
Device does not start (boot).
Power supply interface does not have any
power. Check the power supply cable.
While the device is starting (booting), the following
message appears:
«No Card in CF slot 0 detected !!!»
The CF slot 0 does not contain a CF card. Insert the CF card with the operating system in
the CF slot 0.
CF card in CF slot 0 could not be read
(faulty). Replace CF card.
«Search Subdirectory … not found»
The CF card in CF slot 0 does not have an
OS (operating system).

If the CF card does not contain an operating
system, load one onto a CF card.

Insert the CF card with the operating system
in the CF slot 0.
«<50> Touch is dirty or defect»
(only appears if GALILEO is installed)
Resistive touch is not correctly calibrated.

Start (boot) the device.

Calibrate touch
(
→ Document «MN05010007Z-EN System
Description Windows CE»).
The threaded pins for mounting the device
have been tightened too much. Loosen the threaded pins (observe max.
torque,
→ Chapter 5.4.1,

39).
Device is faulty. Send in your device for repair.
Display remains or becomes dark.
Backlight is switched off. Check the function in the visualization software.
Backlight is faulty. Send in your device for repair.
Touch does not react or does not react correctly to
touch operation.
Resistive touch is not correctly calibrated.

Start (boot) the device.

Calibrate touch
(
→ Document «MN05010007Z-EN System
Description Windows CE»).
Touch is deactivated.

Start (boot) the device.

Activate touch
(
→
Document «MN05010007Z-EN System
Description Windows CE»).