EATON Firmware Update Instructions V1.01 of A-, X-, S- series
EATON Firmware Update Instructions V1.01 of A-, X-, S- series
9
© EATON 2019
1) Insert connection panel cover
1
and tighten with 4 screws with 2 Nm. The tabs
on the connection panel cover must be flush with the enclosing housing. Only
then will the device be properly sealed.
2) Hook in the housing cover at the top
1
and close it at the bottom
2
. The housing
cover must glide into the guides without considerable resistance. The housing
cover must be correctly seated in the housing guide on all sides.
3) Fix the housing cover
1
with 2 screws at the bottom.
4) Check that the charging station is functioning properly.