Eaton XC-CPU101 Series, Instruction Leaflet

Page: 89 / 96

12/14 MN05003004Z-EN
71
Appendix
Compatibility
The functional range of the XC-CPU101 is dependant on the
hardware (HW), the installed operating system (BTS) and the
version of the programming software.
The following overview informs you about the functionality in
dependence on the hardware, BTS and easySoft-CoDeSys versions:
h • The compatibility for older operating systems of the
XC101 is guaranteed.
• Due to the modified control configuration with existing
projects, it might be necessary that the control
configuration may need to be re-entered.
• If a project with a new control configuration is loaded
onto an XC101 with an older operating system version,
only the functions of the older operating system are
available for use.
Functionality Hardware version:
V01 V02 V04
From operating system version: easySoft-CoDeSys-Version:
Basic functionality V1.2 – – F V2.2.5.+Rev. B
PRG default baud rate 57.6 kBit/s Only V1.2 – – V2.3.1
PRG default baud rate 38.4 kBit/s V1.3 – – V2.3.1
Multiple CAN users V1.3 – – V2.3.1
CAN Device V1.3 – – V2.3.1
Programming via CANopen (Routing) V1.3 – – V2.3.1
MMC access – V2.0 – V2.3.1
Interrupt functionality – V2.0 – V2.3.1
RS232 interface in Transparent mode – V2.0 – V2.3.1
Peripheral direct access – V2.0 – V2.3.1
CAN direct access – V2.0 – V2.3.1
CAN baud rate up to 500 kBit/s – V2.0 – V2.3.1
XI/OC bus expansion with XIOC-BP-EXT V1.3 – – V2.3.2
Introduction of the CAN bus load “canload” V1.3 – – V2.3.2
Storage of text data bank on the MMC V1.3 – – V2.3.2
Storage of project information on the MMC V1.3 – – V2.3.2
System events warm and cold start V1.3 – – V2.3.2
Timer interrupt V1.3 – – V2.3.2
Serial interface module XIOC-SER V1.3 – – V2.3.2
PROFIBUS-DP M module – – V3.01 V2.3.2
SUCONET K slave – – V3.02 V2.3.2
Update of the MMC's operating system – – V3.03 V2.3.2
PROFIBUS-DP S module – – V3.10 V2.3.2
Suconet K master module – – V3.10 V2.3.2
Diagnostics – – V3.10 V2.3.2
Free address specification DP – – V3.10 V2.3.2