4
Section I – Introduction
A. Purpose of Manual
This manual has been prepared to assist the users of
Vickers balanced vane type hydraulic single pumps in
properly installing, maintaining and repairing their units. In
the sections which follow, the single pumps are described in
detail, their theory of operation is discussed and instructions
are given for their proper installation, maintenance and
overhaul.
The general series of models covered are V100, V200,
V300, V400, V500 and V2P. The information given applies to
the latest design configuration listed in Table 1. Earlier
designs are covered only insofar as they are similar to the
present equipment.
B. General Information
Related Publications – Service parts information and
installation dimensions are not contained in this manual. The
parts catalogs and installation drawings listed in Table 1 are
available from Vickers.
Model Codes – There are many variations within each basic
model series, which are covered by variables in the model
code. Table 2 is a complete breakdown of the code covering
these units. Service inquiries should always include the
complete unit model number, which is stamped on the pump
cover.
Model
Series
Design No.
(See Table 2)
Parts
Catalog
Installation
Drawing
V100
–10
M-2031-S
M-152060
V200
–12
M-2032-S
M-190082
V300
11
M-2033-S
M-128797
V400
–11
M-2033-S
M-127065
V500
–10
M-1262-S
M-236696
V2P
–10
M-2002-S
M-289405
Table 1. Parts Catalogs and Installation Drawings
Outlet port
Pressure
plate
Body
Bearings
Driveshaft
Seal
Inlet port
Pumping
cartridge
Rotor
Vane
Ring
Figure 1.
Relief valve
Flow control
orifice