![background image](http://html1.mh-extra.com/html/eaton/tripp-lite-series/tripp-lite-series_advanced-users-manual_4236545003.webp)
S
Sppeecciiaall S
Syym
mbboollss
The following are examples of symbols used on the product to alert you to important information:
Danger:
Dangerous voltage levels are present within the UPS. The UPS has an internal
power source (the battery). Consequently, the power outlets may be energized even if the
UPS is disconnected from the AC power source.
Important instructions that must always be followed.
CAUTION:
Batteries present a risk of energy or electric shock or burn from high short circuit
currents. Observe proper precautions. Batteries may contain HIGH VOLTAGE and CORROSIVE,
TOXIC, and EXPLOSIVE substances. Do not dispose of batteries in a fire, as they may explode.
This symbol indicates that you should not discard the UPS or the UPS batteries in the trash.
This product contains sealed, lead— acid batteries and must be disposed of properly. For
more information, contact your local recycling/reuse or hazardous waste center.
Special Symbols
The following are examples of symbols used on the UPS or accessories to alert you to important
information:
RISK OF ELECTRIC SHOCK
- Observe the warning associated with the risk of
electric shock symbol.
CAUTION: REFER TO OPERATOR'S MANUAL
- Refer to your operator's manual for
additional information, such as important operating and maintenance
instructions.
This symbol indicates that you should not discard the UPS or the UPS batteries
in the trash. This product contains sealed, lead‐acid batteries and must be
disposed of properly. For more information, contact your local recycling/reuse or
hazardous waste center.
This symbol indicates that you should not discard waste electrical or electronic
equipment (WEEE) in the trash. For proper disposal, contact your local
recycling/reuse or hazardous waste center.
Eaton, Powerware, and BladeUPS are registered trademarks of Eaton Corporation or its subsidiaries and affiliates.
Phillips and Pozidriv are registered trademarks of Phillips Screw Company.
E
Copyright 2008–2010 Eaton Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be
reproduced in any way without the express written approval of Eaton Corporation.
This symbol indicates that you should not discard waste electrical or electronic equipment
(WEEE) in the trash. For proper disposal, contact your local recycling/reuse or hazardous
waste center for more information.
B
Baatttteerryy W
Waarrnniinngg IInnssttrruuccttiioonnss
•
Internal battery voltage is 12VDC. Sealed, lead-acid, 6-cell battery.
•
Risk of electric shock. All repairs and service should be performed by AUTHORIZED SERVICE
PERSONNEL ONLY. There are NO USER-SERVICEABLE PARTS inside the UPS. The battery
circuit is not isolated from AC Mains Input.
•
Remove watches, rings, and other metal objects from the hands.
•
Wear rubber gloves and boots.
•
Use tools with insulated handles.
•
The system must be properly grounded at all times.
•
The battery supplied with the system contains small amounts of toxic materials. To avoid
accidents, observe the following directives:
–
Servicing of batteries should be performed or supervised by personnel knowledgeable about
batteries and the required precautions.
–
When replacing batteries, replace with the same type and number of batteries or battery
packs.
–
Do not dispose of batteries in a fire. The batteries may explode.
–
Batteries constitute a danger (electrical shock and burning). The short-circuit current may be
very high.
•
Precautions must be taken for all handling. A battery can present a risk of electric shock and high
short circuit current. The following precautions should be observed when working on batteries:
–
Do not lay tools or metal parts on top of batteries.
–
Disconnect the charging source prior to connecting or disconnecting battery terminals.
–
Remove battery grounds during installation and maintenance to reduce the likelihood of
shock
–
Determine if the battery is inadvertently grounded. If inadvertently grounded, remove the
source from the ground. Contact with any part of a grounded battery can result in electrical
shock. The likelihood of such shock can be reduced if such grounds are removed during
Summary of Contents for TRIPP LITE Series
