The enclosure can easily be tipped. Use extreme caution when moving the enclosure.
DO NOT PUSH ON THE CENTER OF DOORS OR SIDE PANELS.
DO NOT USE A “WALKING” METHOD (PUSHING SIDE TO SIDE) TO MOVE THE ENCLOSURE.
Inspect the enclosure
The packaged enclosure
should be inspected for
shipping damage prior to
unpacking. If damage to the
packaging or enclosure is
visible, immediately contact
your Eaton representative and
request the carrier’s agent to
be present when the unit is
unpackaged.
Optional Ramp shown
(RSRMPSTD)
Unpack the enclosure
1. Cut the plastic wrap along
the corrugated corner
protectors to avoid damaging
the enclosure.
2. Carefully remove and
properly discard the
packaging material. Remove
all shipping brackets that
anchor the enclosure to the
pallet.
Remove the enclosure
from the pallet
Ramps (RSRMPSTD ordered
separately) are available to
assist in removing the
enclosure from the pallet.
1. Detach the ramp from its
shipping position by lifting
the ramp upward.
2. Place the ramp into the
open end of the pallet, with
the beveled edge resting on
the floor.
3. Move the enclosure into
position.
Eaton
1000 Eaton Boulevard
Cleveland, OH 44122
United States
Eaton.com
© 2018 Eaton
All Rights Reserved
Printed in USA
Publication No. IL159003EN
October 2018
Eaton is a registered trademark.
All trademarks are property
of their respective owners.
Follow us on social media to get the
latest product and support information.
Follow us on social media to get the
latest product and support information.
Remove shipping bolts
Using a
9
⁄
16
socket, remove
the four shipping bolts and
washers that anchor the
enclosure to the pallet. Also
remove spacer board from
under frame before moving
enclosure from pallet
Unpacking, off-loading from pallet, and moving enclosures
WARNING
•
Use two or more people to move the
enclosure off the pallet.
•
Empty enclosures can weigh as much
as 500 pounds, depending on size and
configuration.
•
Failure to follow this warning could result
in the possibility of the enclosure tipping,
causing serious injury or property damage.
NOTICE
•
Use two people to roll and guide an
enclosure that is equipped with casters.
•
Do
not
attempt to roll the enclosures
sideways.
•
For enclosures that do
not
have casters
installed, use appropriate material handling
and moving devises that are approved by
the installation site.
WARNING
Initial enclosure set-up
For convenience at initial set-up, it may be desirable to remove doors and side panels to help reduce the enclosure
weight and improve access to the interior of the enclosure.
Tools needed for unpacking and
initial enclosure setup
•
Utility knife
•
Level
•
9
⁄
16
wrench or
socket driver
•
7mm hex nut
driver
•
Phillips head
screw driver
•
Cordless screw
gun with Phillips
head bit
•
Site approved
moving device
for enclosures
without casters