Eaton RMD, Installation And Operation Manual

Page: 8 / 20

Installation
4 Eaton 93PM Remote Monitoring Device (RMD) Installation and Operation Manual P-164000516—Rev 1
RMD Installation
If desk mounting:
1. Route the Cat5 network cable from the UPS PXGMS card to the RMD.
2. Connect the Cat5 cable to the RJ45 Ethernet connector on the RMD (see Figure 4).
3. Connect the Cat5 cable to the RJ45 Ethernet connector on the PXGMS card. Refer to the applicable Eaton
93PM UPS Installation and Operation manual for the UPS Minislot location and wiring access information
(see
For More Information section).
4. After the Status indicator of the PXGMS card has illuminated, connect the charger cord micro USB
connector to the micro USB connector on the RMD (see Figure 4). Connect the transformer side of the
charger cord to a 120 Vac service outlet. The RMD should start automatically with the Eaton logo being
displayed. Then the power pushbutton on the front of the RMD will illuminate green and the current
status of the UPS should be displayed. If the display does not start, let the battery charge for 30 minutes
and start manually (see
Powering the RMD on page 7).
If wall mounting:
1. Attach the wall mounting bracket to a wall at the desired location. Use the mounting holes in the bracket
as a template to drill holes. Use hardware applicable to the surface that the bracket is being mounted on
to secure the bracket to the wall.
2. Mount the RMD in the bracket by placing the bottom edge of the RMD into the bracket bottom rail support
and then snapping the top edge under the locking latch (see Figure 3).
3. Route the Cat5 network cable from the UPS PXGMS card to the RMD.
4. Connect the Cat5 cable to the RJ45 Ethernet connector on the RMD (see Figure 4).
5. Connect the Cat5 cable to the RJ45 Ethernet connector on the PXGMS card. Refer to the applicable Eaton
93PM UPS Installation and Operation manual for the UPS Minislot location and wiring access information
(see
For More Information section).
6. After the Status indicator of the PXGMS card has illuminated, connect the charger cord micro USB
connector to the micro USB connector on the RMD (see Figure 4). Connect the transformer side of the
charger cord to a 120 Vac service outlet. The RMD should start automatically with the Eaton logo being
displayed. Then the power pushbutton on the front of the RMD will illuminate green and the current
status of the UPS should be displayed. If the display does not start, let the battery charge for 30 minutes
and start manually (see
Powering the RMD on page 7).
NOTE Ensure the Status indicator of the PXGMS card is illuminated (this may take
approximately two minutes) before plugging in the RMD power source.
NOTE Ensure the Status indicator of the PXGMS card is illuminated (this may take
approximately two minutes) before plugging in the RMD power source.