UPS SYSTEM INSTALLATION
Eaton
Power Xpert 9395P-600 (380V-600V) UPS Installation and Operation Manual
S
P-164000710 Rev 1
www.eaton.com/powerquality
4-5
4.3
Mechanically Joining the Sections (600V Models Only)
NOTE
The following procedure permits the UPS sections to be installed in a location where there is limited
space to slide the sections together from the sides.
NOTE
For the following steps, verify that the forklift or pallet jack is rated to handle the weight of the
section (see Table 3‐1 for cabinet weight).
1.
Using a forklift, move the UPM section to the final installed location.
2.
Remove one top screw and two bottom screws securing the UPM section
wireway panel (see Figure 4‐3). Lift the panel straight up to remove it from the
panel hanger brackets at the top of the cabinet.
3.
Remove the screws securing the top and bottom internal safety shield panels
and remove the panels. Retain the hardware for later use.
4.
Remove the screws securing the corner channel and remove the channel (see
Figure 4‐3). Retain the hardware for later use.
Left Top Panel
Wireway Panel
Left Middle Panel
Corner Channel
UPM Section
Interior Left Side Panel
Figure 4‐3. Section Joining
5.
Remove the screws securing the left top panel and remove the panel (see
Figure 4‐3). Retain the hardware for later use.
6.
Remove the screws securing the left middle panel and remove the panel (see
Figure 4‐3). Retain the hardware for later use.
