How to replace the battery
Contact your MPS12-30 supplier to purchase a replacement battery.
Warning: Risk of explosion if incorrect battery type is used.
Battery can be replaced with MPS12-30 connected to AC wall
socket/outlet.
1.
Press the battery cover and
slide up.
2.
Remove the cover.
3.
Take out the battery.
4.
Disconnect the battery
wires.
5.
Connect the wires to new
battery. Red: positive (+),
Black: negative (-).
Warning: Reverse connection
may damage the MPS12-30.
6.
Place the new battery in the
MPS12-30.
7.
Replace the battery cover.
Recycle old batteries according to local regulations. Or contact
your MPS12-30 supplier for advice.
Specifications
AC Supply
80-260V ac, 45-65Hz
Output Voltage
12V dc nominal, 10.5 - 13.8V dc
Output Power
30W maximum
Battery Type
VRLA, Hot Swappable
12V, 7Ah (12V, 9Ah can be fitted)
Backup time (@ 1A
discharge)
5 hours typical
Recharge Time
4 hours to 90%, without load after
complete discharge
Discharge Prevention
10.5V ± 0.5V
Rated Charging Voltage
13.7V ± 0.25V
Charge Current
2.5A maximum
Output Terminals
Screw connect, maximum wire
size
0.5 - 2.0mm
2
/ 20 - 14 AWG
Alarms Open
collector
DC output cable size
1.5mm
2
/ 14 AWG recommended
DC output cable length
6m / 20 feet maximum
Operating Temperature
0°C to 40°C / 32°F to 104°F
Operating Humidity
0% to 90%
Operating Elevation
0 to 3000m / 0 to 9800 feet
Dimensions
120mm W, 368mm H, 81mm D
4.7" W, 14.5" H, 3.2" D
Weight
3.5kg / 7.7 lb
Eaton Corporation disclaims any liability for direct, indirect, incidental, special or
consequential damages arising out of the application or use of any information
contained in this document. The foregoing disclaimer applies to damages or
personal injury, property damage, loss of operation, loss of profits, loss of product
or loss of time, whether incurred by the purchaser, the purchaser’s employees or
third party.
Information in this document does not constitute a warranty, representation or
guarantee concerning the suitability or performance of Eaton products. No such
warranty, representation or guarantee is expressed or implied.
Information contained in this document is subject to change without further notice.
Subject to the right to use its equipment, Eaton Corporation does not convey any
right, title or interest in its intellectual property, including, without limitation, its
patents, copyrights and know-how.
No part of this document may be reproduced or transmitted in any form, by any
means or for any purpose other than the Purchaser’s personal use, without the
express written permission of Eaton Corporation.
Eaton® is a trade name, trademark, and/or service mark of Eaton Corporation or
its subsidiaries and affiliates. Unless otherwise noted, brands, product names,
trademarks or registered trademarks are the property of their respective holders.
IPN: 997-00012-75A September 2009
© Copyright 2009 Eaton Corporation. All Rights Reserved.
MPS12-30
Micro Power Solutions
Installation and Operation
Guide
