CAUTION:
WHEN FITTING INCOMING
DEVICES ONTO BUSBAR
ENSURE BUSBAR STAB IS
LOCATED INSIDE TERMINAL
CLAMP AND NOT UNDER-
NEATH.
Max Ratings:
Sw itch Disconnector - 125A
RCCB - 90A
Direct Connection - 100A
Im portant
Fit rating label
supplied to cover.
FITTING BLANKING MODULE EMBP
FITTING INCOMING DEVICE
Locate
retaining clip
Tighten
Terminal
Screw s
RECOMMENDED TERMINAL SCREW TIGHTENING TORQUE 2.4 Nm.
Locate device onto
busbar/retaining clip
FITTING CLEAN EARTH KIT
NEUTRAL DISCONNECTION
Slacken
Ter minal
Screw
ENSURE THAT NEUTRAL CONNECTOR IS CORRECTLY REFITTED AND
THAT TERMINAL SCREWS ARE RE - TIGHTENED TO TORQUE 2.4 Nm.
Slacken screw
(Terminal N1)
FITTING AN MCB/RCBO
When fitting an RCBO, trim
RCBO
‘N’ cable to length and
connect to ‘N’ busbar terminal
Locate self tapping
screw s into 2
holes provided
All unused w ays
must be fitted w ith
a Blanking Module
Tighten
Terminal Screw
RECOMMENDED TERMINAL SCREW TIGHTENING TORQUE 2.4 Nm.
Before fitting
to busbar
ensure MCB
terminal is
fully open
IMPORTANT:
Orientate MCB
clip nearest
to busbar
Clip this
side
Clip
fit
