Managing Alarms
Page 30
keypads glows red if the system is unset, and keypads give a short "beep"
approximately every second if the alert has not already been
acknowledged.
To view the cause of the alert:
1.
Make sure the system is unset and that the keypad shows the standby
screen.
2.
Before entering your access code, press
.
3.
Enter your access code or present your proximity tag to the keypad.
The bottom line displays the most recent alert. For example:
OR, for example:
The bottom line may alternate between displaying the zone number
and name (if applicable).
4.
Press
to acknowledge that you have read the alert.
Repeat this step for any other alerts that may be active.
5.
If you see a message similar to the following:
This indicates that the alert has been caused by a Technical Alarm
zone type and the detector is still active. If you can, rectify the problem
and repeat the procedure to reset the alert. Alternatively, press
to
continue (repeat the procedure when you have rectified the problem).
6.
The standby screen is displayed and the beeping stops. The
navigation key continues to glow red until the faults are rectified.
