Eaton Green Motion DC EV Charger User’s Manual P-164001189—Rev 01
21
33..44..22
TTrraannssppoorrttiinngg
Move the charger to the required installation location with a forklift truck or pallet jack rated for at least 1000 lbs
(425 kg).
Please move the charger with the utmost caution!
Tilt restrictions: During transportation, equipment can be damaged if it tilts more than 10 degrees from its
upright position. If unpacking and unloading instructions are not closely followed, the cabinet may tip and cause
serious injury.
Figure 13. Moving the Charger
N
NO
OT
TE
E 1
1
The charger must be stored in its original packaging in a dry environment between -40 °
C and 70 °C.
N
NO
OT
TE
E 2
2
It is recommended to transport the charger to its final destination before removing the
original packaging.
33..44..33
IInnssppeeccttiinngg aanndd U
Unnppaacckkiinngg
1.
Carefully inspect the outer packaging for evidence of damage during transit.
2.
Use a forklift to move the packaged cabinet to the installation site, or as close as possible, before
unpacking.
3.
Remove the protective covering from the cabinet.
4.
Remove the packing material, and discard or recycle in a responsible manner.
5.
Inspect the contents for any evidence of physical damage, and compare each item with the Bill of
Lading. If damage has occurred or shortages are evident, contact an Eaton service representative
immediately to determine the extent of the damage and its impact on further installation.
Summary of Contents for Green Motion GMDC50-CCS
Page 66: ...P 16400118901 P 164001189 01...
