9
GREEN MOTION DC 44/66 EV CHARGER USER MANUAL
MN192005EN March 2023 www.eaton.com
4. How to start and stop charging
Electrical systems or devices must be checked by professional and qualified personnel before commissioning
and switching on the unit for the first time.
Follow these steps to charge:
Step 1.
Check that the EV charger is ready for use with the LED in green. See Chapter 5.
Step 2.
Take the cable connector of the EV charger and plug it to the appropriate car socket.
Step 3.
If the charging station is equipped with a RFID reader, place the RFID card close to the reader to authenticate
yourself.
If the card is recognized, the charging will start. During the charge, the LED starts flashing blue and then shows the state
of charge. See Figure 3.
If the CHAdeMO plug is used, it is mandatory for the user to select the plug on the screen. Refer to the next section.
If the card is not authorized, the charge will not start and an error will appear on the EV charger status display.
See Chapter 5.
If the charging cable is disconnected from the car and there is no power consumption within two minutes, the user is
automatically deauthenticated.
Figure 3. Where to place the RFID card on the EV charger for user authentication
While your vehicle is charging, the EV charger display shows the LED as charging with a breathing blue light. See Chapter
5.
When the battery is fully charged, the EV charger display shows the LED in a steady blue light as fully charged. See
Chapter 5.
Step 4.
To stop charging, unplug the connector from your vehicle. Usually, the connector must be released from inside
your vehicle first. See the instruction manual of your vehicle.
