![background image](http://html.mh-extra.com/html/eaton/epdu-g3/epdu-g3_operation-manual_524480135.webp)
Eaton ePDU G3 Operation Manual P-164000277—Rev 1
www.eaton.com/ePDU
127
Chapter 9
Maintenance and Alarms
This section explains maintenance functions for the Eaton Enclosure Power Distribution Unit (ePDU) G3,
including:
l
Preventive maintenance
l
Equipment disposal
l
Replacing the ePDU Network Management and Control (eNMC) module
l
Updating Firmware
l
Alarms
Preventive Maintenance
For the best preventive maintenance, keep the area around the ePDU clean and dust-free. If the atmosphere
is very dusty, clean the outside of the system with a vacuum cleaner. Do not to exceed 60°C (140°F) for best
performance.
Equipment Disposal
Contact your local recycling or hazardous waste center for information on proper disposal of the used ePDU.
CAUTION
Do not discard waste electrical or electronic equipment (WEEE) in the trash. For proper disposal,
contact your local recycling/reuse or hazardous waste center.
Replacing the ePDU Network Management and Control Module
NOTE
Handle the eNMC module with care. Be aware that there is a risk of electrostatic
discharge (ESD). As a preventive measure, wear ESD protection, such as an ESD
shoe strap, while replacing the eNMC module. Do not put stress on the connection
cable during installation.
To replace the eNMC module (see Figure 76):
1
2
3
4
5
6
Figure 76. Replacement Procedure