![background image](http://html.mh-extra.com/html/eaton/epdu-g3/epdu-g3_operating-manual_524483031.webp)
Installation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5
22
Using Clip Feet and Cage Nuts on a Square-hole Rack
To install the ePDU with clip feet secured by cage nuts:
1.
Locate the cage nuts (supplied).
2.
Are you mounting the ePDU in line with the rail or away from the rail (offset)?
l
If in line with the rail, go to Step 3.
l
If away from the rail, go to Step 5.
3.
ePDU in line with the rail.
Position and lock two cage nuts far enough apart to stabilize the top and
bottom of the ePDU when mounted on the rail. Insert the cage nuts with a flat-blade screwdriver (see
Figure 19).
4.
Locate the two clip feet and four M6 screws (supplied). Position one mounting clip foot at a cage nut and
secure the mounting clip foot to the rail with a screw. Repeat for the second mounting clip. Tighten the
screws. Go to Step 8.
Figure 19. Attaching the Clip Feet and Cage Nuts
NOTE
You can install the mounting clip feet vertically or horizontally.
NOTE
If a square-hole rack is used, cage nuts must be installed. Use a cage nut insertion
tool or a flat-blade screwdriver to install the cage nuts.