![background image](http://html.mh-extra.com/html/eaton/epdu-g3/epdu-g3_operating-manual_524483026.webp)
Installation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5
17
Chassis Hole Pattern (EMEA models only)
The EMEA models have markings and extra holes on the back of the ePDU to accommodate different mounting
requirements in EMEA racks.
You can move the ePDU up or down in the rack in 10mm intervals to ensure best fit. This standard system uses
622 mm, 933 mm, 1244 mm, 1384 mm and 1556 mm, depending on the overall length of the ePDU (see
Figure 11).
Figure 11. Raise or Lower Mounting Position in the Rack
You can also choose the appropriate distance between the keyhole buttons based on 0 value (see Figure 12).
Figure 12. Change Distance Between Button Mounts for Different Racks
Mounting Buttons
The mounting buttons for 0U vertical ePDUs are factory installed. This is a two-sided button that provides either
a 2.1 mm or 2.3 mm mounting channel for a custom fit. If you discover that the rack wall is too thick or too thin
and the button does not secure the ePDU, unscrew and remove the button from the ePDU. Then, flip it to the
reverse side (see Figure 13). To distinguish the sides, one side is marked with a black painted ring. For EMEA
models, you must not see the black ring when installed.
NOTE
Only use the provided screws to mount the buttons.