4.2 DISCONNECT AND LOCKOUT/TAGOUT
The disconnect handle is furnished with three (3) holes for lockout/tagout purposes.
1. Turn handle to the ‘OFF’ position.
2. Depress lockout tab at the end of the handle.
3. Install OSHA approved lock or tag.
4. Release lockout tab.
WARNING
To avoid ignition of explosive atmospheres, all circuits must be de-energized
before opening cover.
CAUTION
To avoid damage to the integral disconnect operating mechanism, be sure the
disconnect coupling is in the off position before closing cover.
Disconnect
shaft
Disconnect
coupling
‘OFF’ position
3.6 COMMUNICATION MODULES
Available options:
Protocol
Suffix
Profibus .......................................
CP
Devicenet ....................................
CD
CAN Open ...................................
CC
Modbus .......................................
CM
Ethernet .......................................
CE
4. GENERAL OPERATION
4.1 KEYPAD INTERFACE
*To review selection criteria, observe the control pad screen through the viewing window.
Criteria is identified in the lower corners of the control pad corresponding to the buttons (as
shown). Refer to the drive manufacturer’s manual for additional instruction on the proper use and
capability of the keypad interface.
All communication modules will be installed in ‘Slot 3’ on the VFD. Plug in and
fasten using the integral screw provided.
IF 1619 • 05/18 Copyright
©
2018, Eaton’s Crouse-Hinds Division Page 8
Left
soft
key
Up, down,
left and right
arrow keys
Right
soft
key
Drive
start
Drive
stop
Lockout tab
