CAM-INT-00
Internal IP Camera
Introduction
The CAM-INT-
00 is a 1 / 2.7” Mega-Pixel CMOS
sensor IP camera with a built-in web server. The
user can view real-time video via IE browser. It
supports H.264, and M-JPEG video compression,
providing smooth and high video quality.
Supports Wired Ethernet connections and Wi-Fi
connectivity with a user friendly interface, it is an
easy-to-use IP camera for security applications.
The camera support a web interface that allows
authorised users access the camera menus and
change settings.
The only configuration of the Camera that the
Installer is required to do is set the IP address
and/or Wi-Fi settings and also set up the
image/focus.
The panel will configure all required settings for
visual verification of the camera once the IP
address of the camera has been entered in to the
panel.
Package contents:
1 x internal IP camera
1 x bracket
1 x screw package
1 x quick installation guide
Note: It is recommended you follow these
instructions and configure the device before
mounting it.
This product must be installed by qualified service
personnel.
Installing the unit
Connections
The camera connectors are as below.
Connect the power and the Ethernet cable to the
camera and set it according to your network
environment.
Mounting Bracket
Use the screws to lock the bracket to the wall or
ceiling, and then connect the camera to the
bracket. There’s a knob on the back of the
bracket, after the knob is loosened you can adjust
the angle of camera; tighten it to fix the angle.
Adjust focus
Use the rotary dial to adjust
focus until the image is clear.
Power Over
Ethernet (Optional)
802.3af, 15.4W PoE Switch is recommended
Power over Ethernet (PoE) is a technology that
integrates power into a standard LAN
infrastructure. It allows providing power to a
network device, such as an IP phone or a
network camera, using the same cable as that
used for network connection. It eliminates the
need for power outlets at the camera locations
and enables easier application of uninterruptible
power supplies (UPS) to ensure an operation of
24 hours a day, 7 days a week.
IP assignment
By default the camera will be configured to
obtain a DHCP IP address when plugged into a
DHCP enabled router.
Alternatively the camera can be connected to a
WPS enabled router. The WPS learn mode is
initiated by pressing the WPS button until the
blue light is flashing, once the camera has
synced with the WPS enabled router then the
blue light with remain on.
If the camera does not detect a DHCP
connection then it will switch to a fixed IP
address of 192.168.0.200.
Connect to WiFi using
WPS
1.
Locate WPS button on the Wi-Fi router
2.
Depending on the make and model
this may start to flash. Press to
activate the WPS feature (consult
router manufacturer for details on
WPS function)
3.
Locate the WPS button on rear of
camera
4.
Press and hold WPS button till the blue
LED starts to flash. When the camera and
