![background image](http://html.mh-extra.com/html/eaton/bussmann-series/bussmann-series_manual_524757013.webp)
13
Technical Data
MN019001EN
Effective November 2015
Bussmann series
PV Combiner box
EATON
www.eaton.com
m
WARNING!
Mounting
The box may be wall or stand mounted using a set of mounting
brackets designed for the selected enclosure. These are supplied
with the required screws in every combiner box, and must be
used if the box is to be wall or stand mounted. If the combiner
box has an external door, the enclosure must be mounted so that
the hinges are in the vertical plane.
Mounting brackets
The following guidelines should be adhered to when mounting
your combiner box. Mounting the combiner box is done so at
your own risk.
•
Ensure the combiner box is mounted so that the connection
face is facing downwards.
•
Do not mount the combiner box in an inclined position.
•
Only the supplied mounting brackets may be used.
•
Ensure there at least 2 people available to mount the combiner
box – it may weigh up to 75kg.
•
Before installing the combiner box, ensure that none of the
exterior cable glands or plugs have been damaged in transit. If
this is the case, please contact Eaton [email protected]..
Mounting location requirements
The following guidelines should be adhered to when mounting
your combiner box. Mounting the combiner box is done so at your
own risk, as is customer selection of a mounting location.
•
The mounting location should be in a well-ventilated area and
should not be a living area or office.
•
The mounting locations should be safely accessible at all times
to aid any required servicing.
•
No escape routes should be blocked as a result of the mounting.
•
The location should be load bearing and suitable for both the
weight and the dimensions of the combiner box.
•
The mounting location must not be exposed to direct sun light.
Take wall properties into account when mounting the combiner box.
1. Mark the position of the drill holes on the wall or stand.
2. Drill holes on the marked positions.
3. If necessary, insert the screw anchors.
4. Attach the mounting brackets with the screw supplied.
5. Fasten the combiner box to the wall or stand using suitable screws and
washers.
m
CAUTION!
Mounting the combiner box
The combiner box may be wall or stand mounted using the supplied
kit. Different size combiner boxes have mounting brackets which are
applied in different manners, as per the diagrams below.
For external dimensions 1050 x 850 sized combiner boxes –
For all other sizes of combiner boxes -
Figure 6. Fitting mounting brackets