Top and bottom panel installation
1. Install twelve #10-24 x
1
∕
2
" phillips head screws
(supplied) at the top and bottom of the End
Panels as shown in figure 5. Do not screw
them in all the way; they should protrude
approximately
1
∕
8
"
2. Position the Top and Bottom Panels between
the End Panels above the screws. Lower the
panels so that all of the screws engage the
corresponding slots in the panels. See figure
6. Next, push the Top and Bottom Panels back
towards the rear to seat the screws. See figure
7. Tighten all screws to secure the panels.
3
91212
L a b S l i d i n g D o o r
C o m p a r t m e n t
I n s t a l l a t i o n
1. Install twelve #10-24 x 1/2” phillips head screws
(supplied) at the top and bottom of the End Panels as
shown in figure 5. Do not screw them in all the way;
they should protrude approximately 1/8”.
End Panel
1/8”
End Panel
Figure 7
2. Position the Top and Bottom Panels between the End
Panels above the screws. Lower the panels so that all
of the screws engage the corresponding slots in the
panels. See figure 6. Next, push the Top and Bottom
Panels back towards the rear to seat the screws. See
figure 7. Tighten all screws to secure the panels.
Bottom Panel
Figure 6
End Panel
TOP AND BOTTOM PANEL INSTALLATION
Figure 5
#10-24 x 1/2” phillips
head screws
Screws
Top Panel
Push back
Bottom Panel
Screw
Rounded edge
towards front
Rounded edge
towards front
3
91212
L a b S l i d i n g D o o r
C o m p a r t m e n t
I n s t a l l a t i o n
1. Install twelve #10-24 x 1/2” phillips head screws
(supplied) at the top and bottom of the End Panels as
shown in figure 5. Do not screw them in all the way;
they should protrude approximately 1/8”.
End Panel
1/8”
End Panel
Figure 7
2. Position the Top and Bottom Panels between the End
Panels above the screws. Lower the panels so that all
of the screws engage the corresponding slots in the
panels. See figure 6. Next, push the Top and Bottom
Panels back towards the rear to seat the screws. See
figure 7. Tighten all screws to secure the panels.
Bottom Panel
Figure 6
End Panel
TOP AND BOTTOM PANEL INSTALLATION
Figure 5
#10-24 x 1/2” phillips
head screws
Screws
Top Panel
Push back
Bottom Panel
Screw
Rounded edge
towards front
Rounded edge
towards front
#10 - 24 x
1
∕
2
" phillips
head screws
Figure 5
Figure 6
Figure 7
End panel
End panel
Top panel
Rounded edge
towards front
Bottom panel Rounded edge
towards front
Bottom panel
Push back
Screw
1
∕
8
"
Screws
