Eaton 9PX10KSP, Installation And User Manual

Page: 24 / 192

Page 24
614-00205-01_EN
6.2 LCD description
After 5 minutes of inactivity, the LCD displays the screen saver.
The LCD backlight automatically dims after 10 minutes of inactivity. Press any button to restore the screen.
Operation status
Load/equipment status
Battery status
Efficiency information
The following table describes the status information provided by the UPS.
Note: If other indicator appears, see "Troubleshooting" on page 40 for additional information.
Operation status Cause Description
Standby mode The UPS is Off.
Equipment is not powered until
button is pressed.
Online mode The UPS is operating normally. The UPS is powering and protecting
the equipment.
Battery mode
1 beep every 10 seconds
A utility failure has occured and
the UPS is on Battery mode.
The UPS is powering the equipment
with the battery power.
Prepare your equipment for
shutdown.
End of backup time
1 beep every 3 seconds
The UPS is on Battery mode and
the battery is running low.
This warning is approximate, and
the actual time to shutdown may
vary significantly.
Depending on the UPS load
and number of Extended Battery
Modules (EBMs), the "Battery Low"
warning may occur before the
battery reaches 20% capacity.
High Efficiency mode The UPS is operating on High
Efficiency mode.
The UPS is powering and
protecting the equipment.
Bypass mode An overload or a fault has occurred,
or a command has been received,
and the UPS is in Bypass mode.
Equipment is powered but not
protected by the UPS.
6. HMI and settings