4.
Remove the protective wood container from the cabinet.
For the following steps, use pincer type pliers or a large flat blade screw
driver to straighten the securing tabs.
a) Straighten the tabs securing the top panel of the wooden container
to the side panels of the container.
b) Remove the top panel.
c)
Straighten the tabs securing the side panels of the container to the
front and back panels of the container.
d) Remove the side panels. The side panel with sloped support blocks
is designed to be used as a ramp. Retain it for later use.
e) Straighten the tabs securing the front and back panels of the
container to the bottom of the container.
f)
Remove the front and back panels.
5.
Remove the inner protective packaging. Retain the parts kit and ramp
brackets packed at the top of the cabinet.
6.
Recycle the remainder of the outer shipping container and the inner
protective packaging in a responsible manner.
7.
Inspect the contents for any evidence of physical damage, and compare
each item with the Bill of Lading. If damage has occurred or shortages
are evident, contact an Eaton service representative immediately to
determine the extent of the damage and its impact on further installation.
Note: If you do not install the UPS immediately, protect the unpacked cabinet
from moisture, dust, and other harmful contaminants. Failure to store and
protect the UPS properly may void your warranty.
8.
Remove four bolts securing the front shipping bracket to the cabinet and
four bolts securing the bracket to the pallet.
9.
Remove the front shipping bracket.
If installing the cabinet permanently, retain the shipping bracket and
securing hardware for later use.
Eaton 93E Generation 2 UPS 100-200 kVA
(380/400/415V)
User's and installation guide
©
Eaton Corporation plc 2019. All rights reserved.
Revision: 002
Document ID: P-164000848
50 (118)
