Replacement Parts
ITEMS
DESCRIPTION
EATON STYLE NUMBER
VEEDER COUNTER
VEEDER COUNTER
OPERATOR LINK
592C040H01
8864A37H01
WARNING
VERIFY CIRCUIT BREAKER IS OPEN, CLOSING SPRINGS ARE
DISCHARGED AND CONTROL POWER IS DISCONNECTED.
REFERENCE: THE SPRING RELEASE COIL IS THE COIL ON THE
LEFT SIDE, LOOKING INTO THE CIRCUIT BREAKER, WITH
THE GREEN “PUSH TO CLOSE” LABEL. THE SHUNT TRIP
COIL IS THE COIL ON THE RIGHT SIDE, LOOKING INTO THE
CIRCUIT BREAKER, WITH THE RED “PUSH TO OPEN” LABEL.
Adjustment of the Operations Counter
Verify that the circuit breaker is open and discharged.
Locate the circuit breaker operations counter.
Unscrew the counter from its mounting. Disconnect the
operating link.
Loosen the handle screw on the counter. Align the back
edge of the arm with back edge of counter operator and
tighten the screw.
Attach the operating link (with the bent leg pointing
down and away from you) to the lower hole in left
side of flag link and to counter handle, and mount the
counter to bracket using the two mounting screws and
hardware. Be sure the hardware is tight.
The counter number should change when assembling.
otee:
N
The handle on the counter should point down and to the
rear with circuit breaker in the open position.
otee:
N
Operate the circuit breaker 5 times mechanically.
otee:
N
Visually inspect that the counter changes state during
operations.
Component
Adjustment
Adjusting the operations counter on a 150VCP-W25 mechanism.
14
EATON
|
Visual Instruction Booklet Essentials | 150VCP-W 25kA 1200A | January 2017