Eaton Compressor POLAR AIR P01ISXXP10V080VXXXX, User Manual

Page: 28 / 42

Splash Lubricated, Air Compressor Pumps
11.
DO NOT
use air tools that are rated below the maximum rating of the compressor. Select air tools, air hoses,
pipes, valves, filters and other fittings accordingly. DO NOT exceed manufacturer’s rated safe operating
pressures for these items.
12. Make sure all hose connections are adequately secured to prevent tools or hose ends from being
accidentally disconnected.
1. This unit may or may not contain oil when shipped. Be sure to check for proper oil level before operating the
compressor. Oil should be in center of site glass. See figure 5.
2. Check for proper belt tension. There should be 1/2 inch slack. Refer to figure 3, pg. 4.
3. Push power switch to make sure system is working.
4. Ensure motor rotation is correct. Refer to unit operating instructions if necessary.
1. Make sure repairs are done in a clean, dry, well lighted and ventilated area.
2. When cleaning, use air pressure less than 30 PSIG (2.1bar).
NEVER use flammable solvents for cleaning
purposes. Also use effective chip guarding and personal protective equipment per OSHA standard 29 CFR
1910.242 (b).
NOTICE
Use only Airbase Industries oil (PN: APOL03000G1). Use of any other
product will cause product damage and void the warranty.
Always make sure main power is off before touching belts or other
moving parts of compressor.
WARNING
Disconnect, tag and lock out power source then release all pressure
from the system before attempting to install, service, relocate or
perform ANY maintenance.
WARNING
Start-Up
Safety Steps
Maintenance
9