深圳市普伦特科技有限公司
www.easythreed.com
11 / 10
6.3.
The problem of print model misplaced
（
1
）
Slice model error:
The most common software used today is Cura and Repetier. Most of them are open source, so
we can't guarantee the stability and professionalism of the software, and every design model drawing
is not necessarily perfect for the software, so first of all, printing dislocation model diagram is not
changed, slice the model again.
（
2
）
Model drawings problem:
After slicing, the model is always misplaced. Change another model to print
, or try a model you printed successful before, to check if it is model file problem.
（
3
）
The print nozzle is forcibly blocked during printing:
First of all, you can't touch the moving print head with your hand during the printing process.
Secondly, if there are accumulated things on the up layer of the model , the next printing will repeat
the increase of accumulated tumors. A certain degree of hard accumulated tumors will block the
nozzle from moving normally and cause the motor to lose step leading to dislocation.
（
4
）
Voltage instability:
（
5
）
motherboard problem
：
The above problems can not solve the problem, and all models print with same problem , replace
the motherboard.
6.4. Printing Quality not good.
（
1
）
the surface of the printed model with area tumors
：
①nozzle
temperature too high
。
②he
flow rate of filament is too large. The Slicer software has the flow rate setting of filament. The
default value is 100%. Can Reduce to 80% to print
。
③
when do slice ,set the right diameter of filament.
（
2
）
Printing surface is very poor after printing support treatment
Support density decrease to 10%. Easy to remove
（
3
）
Filament Quality Low
：
In Market, there are different level quality filament, Filament from Easythreed is the best
choice, Manufacturer did a lot of test , Filament suitable for the Printer best.
Thank you for choosing Easythreed 3D Printer
Shenzhen Easythreed Technology CO.,Ltd
http://www.easythreed.com
