12
2. Installation and Configuration
2.5 Resetting to the Factory Default Settings
To reset the EC-2M-OV39N HD Camera to the original factory settings, use the Reset button
(SW1) on the board of the dome camera, as described below:
Using the Reset Button
Follow the instructions below to reset the HD Camera to the factory default settings using the
Reset button.
1.
Power off the HD Camera by disconnecting the power adapter or Cat5e/Cat6
network cable if it is connected to Power over Ethernet.
2.
Open the lens cover.
3.
Press and hold the Reset button (SW1) on the board with your finger while
reconnecting the power.
4.
Keep the Reset button (SW1) pressed during about 2 seconds.
5.
Release the Reset button (SW1).
6.
The HD Camera resets to factory defaults and restarts after completing the
factory reset.
7.
Close the lens cover.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.
Please consult with NUVICO Technical Support first before doing so since this can
interrupt the communication to the recorder
