PANTONE 072 C
PANTONE 123 C
Dear Customer
Thank you for purchasing the Twin Beam Security Light.
BATTERY INSTALLATION
1. Remove the battery cover (located on the opposite side of the LED lights) from back using a
small Phillips head screwdriver.
2. Insert 4xAA batteries (not included) as indicated inside the battery compartment and replace
the battery compartment and screw.
INSTALLATION INSTRUCTIONS
1. Determine the exact location where you want to install the light fixture.
*Two different installation options are provided, it is recommended to use the standard installation
wherever possible
STANDARD INSTALLATION
1. Prepare area where you what to mount the light unit, clearing any loose debris, and ensuring
that you have adequate space to mount the light before drilling any holes. There needs to be a
small space left above the unit so that it can be hooked over the screws.
2. Mark where you want the two screws to be mounted, they should be 57mm apart and horizontal.
3. Drill pilot holes using a 1.5mm drill bit to a depth of 19mm.
4. If you hit a wall stud, or are fixing to a wooden surface, use only the supplied screws to install the
light fixture. If the wall is hollow, or you are drilling in to masonry, using the pilot holes as guide,
drill again using a 6.5mm drill bit and insert a wall anchor into each hole. Tap each wall anchor
lightly with a hammer, until they are flushed with the wall surface.
5. Thread a screw into each hole (or wall anchor if used) leaving 3.5mm of the screw un-threaded,
to secure the light fixture.
6. Match the holes on the base of the light fixture (narrow end of holes facing upwards) with the
screw heads and slide downward to secure the light fixture.
DOUBLE SIDED ADHEVISE STRIP INSTALLATION (INCLUDED)
1. Choose a smooth surface for best adhesion and wipe clean.
2. Peel one side of the adhesive strip and apply to the base of the light. For best results, place the
adhesive strip in a triangle shape around the base.
3. Peel the other side of the adhesive strips and press the light fixture firmly against the smooth
surface.
NOTE – For ease of access it is recommended to mount using the standard installation. Using
the adhesive strips instead of the standard installation you are limiting access to the battery
compartment, and it would be necessary to un-mount the unit to gain access. Therefore please
ensure that the surface you are using will not be damaged when the unit is removed with the
adhesive strip. To reattach you will need new adhesive tape, not supplied.
OPERATION
1. Slide the ON/OFF switch (located on the side of the light) to the ON position (A).
2. Each light fixture may be adjusted to provide lighting in any direction. The swivel base of each
light rotates 360
0
and each lamp angle adjusts 180
0
to provide the light where desired.
3. The motion sensor (located below the LED lights) will detect motion within a 90
0
(maximum 10 feet distance).
4. When motion is detected the LED lights will turn. The LED’s lights will automatically turn off
after 20 seconds, if motion is no longer detected.
Paper weight 60gsm
Support Line: 0303 031 0777
For more innovative products from Easylife please visit:
www.easylifegroup.com
everyday solutions
™
Est. 1992
A
B
C
