HOW TO ASSEMBLE THE WEED BURNER:
Before you assemble the weed burner, check you have got all above parts.
If the parts are damaged, DO NOT USE, ask help from customer service and don’t attempt to repair yourself
Step 1:
Insert middle pole into the weed burner main body by following the arrows.
Make sure the button has clicked into place.
Step 2:
Insert top handle into other side of the middle pole. Ensure the
indentation aligns correctly. Never force the poles in.
Step 3:
Twist the nozzle onto the weed burner hot air nozzle following the
indentation and make sure it is secured. If it is loose or moving it is
not correctly and must be done again.
OPERATION:
WARNING: Always use this item with caution. Do NOT cover the air vent during use as this can cause
overheating, possibly resulting in malfunction or injury. Do not touch the hot nozzle.
Before use always make sure the machine, power cord and plug are undamaged and in good working condition, make sure
the nozzle is not blocked
Temperature settings
With the temperature switch (1) you can set weed burner to be two different setting.
•
Setting I
50 °C (venting/ cooling)
•
Setting II
600 °C
To turn off the weed burner
Push the switch (1) on position 0.
To turn on the weed burner
Push the switch (1) in position I or position II.
• Insert the plug into the socket. Make sure the switch is in off position 0.
• Push the switch to position I
• The device takes about 45 seconds to reach operating temperature.
Do NOT leave the device unattended while switched on
• To treat the weeds, hold the nozzle over the weeds for about up to 10 seconds, which will destroy the cell structure of
the weed. As a result, the weed dies within a few days. Do not exceed 10 seconds each time.
• For an efficient treatment the nozzle should be held around 3 to 5 cm above the weeds
• The effect of the treatment can be seen after treatment but it does not mean the weed will be burned off. If the root has
not been pulled out, the weed may come back, repeat the same treatment process above. In the case of very leafy
plants, the treatment may have to be repeated several times at intervals of 1 to 2 weeks.
• Turn off the machine by setting the switch to “0”
• Always allow the machine time to cool before storing it.
DO NOT
touch the nozzle while it is cooling down.
COOLING DOWN:
• Leave device to run for at least one minute in position I.
• Switch off the device.
• Pull the plug out of the socket.
• Pull out the stand (3) and leave the weed burner in a resting position with space around it to completely cool down.
• Once called remove the accessories.
