3.
To expand the EasyFold PRO 2.0,
grasp the push bar and pull up while holding down on the
seat to expand the chair and complete the assembly:
4.
Sit on the chair and lean backwards to make sure the clip locker, which is located below the
seat to the rear of the EasyFold PRO 2.0, has locked the seat into place.
5.
Install the controller into the open slot on the arm of the chair, on the right side (if the user
needs, this can be changed to the left side). Tighten the knob located under the armrest to secure
the controller in place.
6.
Connect the controller wire harness to the CPU wire harness. Take care that the pins line up
properly as the arrow indicates, so that they do not get bent, broken or damaged.
Summary of Contents for PRO 2.0
Page 1: ......
Page 6: ...Specification Diagram...
Page 13: ...7 Insert two batteries and push to the back of the battery holder...
