Assembly
5
Attach the turbo brush head to the main body
Insert the turbo brush head (#2) into the main body (#1) until you hear an
audible clicking noise.
To disassemble the turbo brush head from main body, press the red main
body attachment release button (#15) then remove the turbo brush head.
Attach the 2-in-1 crevice/brush tool to the extension pole & main body
Change the 2-in-1 crevice/brush tool to the desired accessory of crevice tool
or brush tool by pressing on the tab (see below) and pulling the brush up or
down until it locks into place.
Insert the 2-in-1 crevice/brush tool (#3) into the connecting joint (#4).
It does not click into place. Insert the connecting joint into the bottom of the
extension pole (#6) until you hear an audible clicking noise. Insert the top of
the extension pole into the main body (#1) until you hear an
audible clicking noise.
To disassemble the 2-in-1 crevice/brush tool from the pole, pull the 2-in-1 tool
straight out from the connecting joint. It is not clicked into place. Press the
red pole attachment release button (#7) then remove the connecting joint.
To disassemble the extension pole, press the red main body attachment
release button (#15) then remove the extension pole.