Cleaning
18
− Never place the product in a dishwasher. It would be
destroyed as a result.
− Disconnect the power adapter
21
from the product or remove the handheld
section
11
from the wall bracket
19
.
− Let the product cool down completely.
− Allow all parts to dry completely after cleaning.
Empty the dust container and clean the HEPA filter
1. Slide the MOVE release button
8
downwards to release the dust container
5
from the handheld section
11
(see
Fig. G
).
2. Hold the dust container over a dustbin. Press the PUSH release button
7
. The
lid
6
on the dust container will flip open (see
Fig. H
).
3. Empty the dust container.
4. Close the lid and make sure it clicks audibly into place.
5. Pull the HEPA filter
3
together with the filter holder
4
out of the dust container.
6. Remove the HEPA filter from the filter holder. Tap both parts above a dustbin to
remove the accumulated dirt. You can wash the filter holder and HEPA filter with
clean water. Subsequently, let the HEPA filter air-dry completely.
7. Replace the dry HEPA filter back into the filter holder.
8. Slide the filter holder back into the dust container.
9. Reinstall the dust container on the handheld section. To do so, place the plastic
hook on the dust container into the notch on the underside of the handheld
section. Then tilt the dust container towards the handheld section until it sits
properly in place. Ensure that the MOVE release button snaps fully into the
handheld section again at the top.
Cleaning the brush roll
Check the brush roll
27
regularly for blockages. Remove any hair, strings or dirt
accumulated on the brush roll.
Take the brush roll out of the floor nozzle
22
to make cleaning easier.
Removing the brush roll
1. Disconnect the floor nozzle
22
from the long tube
17
or the handheld section
11
.
2. Slide the release latch
26
(located on the underside of the floor nozzle) all the
way outwards. Remove the brush roll
27
(see
Fig. I
).
