Charging the batteries
14
Installing the wall bracket
WARNING!
Risk of electric shock!
Improper handling of the product may result in electric shock.
− Before you start drilling into a wall, ensure that there are no
electrical wires or water pipes in it. Drilling into a live wire may
cause fatal injury!
Choosing the installation location
− Find a suitable location to install the wall bracket, where the product will not
be exposed to direct sunlight or other sources of heat. There should be a mains
socket close by that the power adapter can reach.
Installation
1. Using the mounting holes on the wall bracket
19
as a template, mark the
positions of the holes to be drilled on the wall.
2. Insert the nozzle holders
20
in the designated slots on the wall bracket (see
Fig. B
).
3. Use an electric drill
28
to drill holes at the marked positions and insert the
dowels
23
into the holes (see
Fig. C
).
4. Tighten the screws
24
such that the screwhead sticks out a few millimetres. Use
the designated holes to mount the wall bracket on the two screws. Ensure that the
screws are inserted properly into the mounting holes. The wall bracket should be
as flush with the wall as possible.
5. Insert the nozzles
14
/
15
/
16
into the nozzle holders on the wall bracket’s
sides.
Charging the batteries
The battery status indicator
10
shows the batteries’ charge level. If the batteries are
running low, all bars will flash for a few seconds before the product switches off by
itself.
While the batteries are charging, one of the bars will keep flashing to indicate the
current charge level. The batteries are fully charged when all bars light up.
Recharge the batteries only when the product’s suction is weak.
