To order parts and supplies: 800.343.9353 >> eastwood.com
11
• The Table Travel Lock Lever (X Axis)
“17”
is located at the Front of the Table and
is used to lock the Table in position
(FIG 15)
.
• The Cross-Feed Lock Lever (Y Axis)
“18”
is located at the Right side of the Base
and is used to lock the Table in position
(FIG 15)
.
• The Column supporting the Mill Table is assembled in a vertical position. It can
be tilted up to 45° in either direction, left or right, for the purpose of performing
angled milling. This is controlled by the large 36mm Locknut on the Pivot of the
Column
(FIG 16)
.
• To Tilt the Column:
- SLOWLY Loosen the 36mm Locknut with the included 36mm Wrench
to release the clamping action keeping it vertical.
- While securely gripping the Column, allow it to pivot in the desired
direction while reading the Gauge and Pointer located at the Base of the
Mill and Column.
NOTE:
The pointer remains fixed on the Mill Base while
the Gauge will rotate with the Column
(FIG 17)
.
- When the desired angle is reached, securely tighten the large 36mm Nut
to lock the Column in place.
Before attempting tilting of the Column, the Mill MUST be
securely bolted to a firm, level and secure surface as an extreme
imbalance condition will result when the Column is tilted.
CRUSH/PINCH INJURY HAZARD!
The Column is heavy and will suddenly swing to the side
without support.
FIG. 15
FIG. 16
FIG. 17
Table Travel
Lock “17”
✓
Cross Feed
Lock “18”
✓
Angled
Tilt
