© Copyright 2018 Easthill Group, Inc. 7/18 Instruction item #32406Q Rev 1
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: [email protected]
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com
OPERATION
• Grip the lamp housing and rotate Magnetic Base through 360° in the vertical and
180° horizontally on the pivoting Base
(FIG 1)
.
• Place the base or rear of housing against any ferrous metal surface for magnetic attachment.
• Release Retractable Swivel Hook to hang from overhead objects.
• Depress and release round Button located at front of Housing once for High-Intensity
COB LED Illumination and a 2nd time for the Flashlight
(FIG 1)
.
• Depress Button once again to turn off.
Batteries will slowly discharge without use and must be charged every
3 months even if the light has not been used.
Do Not charge batteries in temperatures below 40°F [4.4°C].
CHARGING
• When the LED power indictor located at the
front of the Housing flashes RED, the battery
requires charging.
- Flip up rubber seal and plug the barrel
terminal of the included 120VAC Charger
cord or 12VDC power cord into the barrel
connection port at the rear of the
housing
(FIG 2)
.
- Plug the 120VAC Charger cord into a
120VAC wall outlet or the 12VDC Connector
into a vehicle 12 power port.
- Plug wall unit into properly grounded 120 VAC, 60 Hz. outlet
- Allow 4 hours for full charge.
- The indicator LED at the front of the Housing will illuminate RED while charging then
change to GREEN indicating full charge
(FIG 1)
.
- Close Charging Port Cover to maintain IP-20 rating.
FIG. 2
